[HARLEQUIN][Common Lisp HyperSpec (TM)] [Previous][Up][Next]


Type SHORT-FLOAT, SINGLE-FLOAT, DOUBLE-FLOAT, LONG-FLOAT

Supertypes:

short-float: short-float, float, real, number, t

single-float: single-float, float, real, number, t

double-float: double-float, float, real, number, t

long-float: long-float, float, real, number, t

Description:

For the four defined subtypes of type float, it is true that intermediate between the type short-float and the type long-float are the type single-float and the type double-float. The precise definition of these categories is implementation-defined. The precision (measured in ``bits'', computed as p log 2b) and the exponent size (also measured in ``bits,'' computed as log 2(n+1), where n is the maximum exponent value) is recommended to be at least as great as the values in the next figure. Each of the defined subtypes of type float might or might not have a minus zero.

Format  Minimum Precision  Minimum Exponent Size  
----------

Short 13 bits 5 bits Single 24 bits 8 bits Double 50 bits 8 bits Long 50 bits 8 bits

Figure 12-12. Recommended Minimum Floating-Point Precision and Exponent Size

There can be fewer than four internal representations for floats. If there are fewer distinct representations, the following rules apply:

Compound Type Specifier Kind:

Abbreviating.

Compound Type Specifier Syntax:

short-float [short-lower-limit [short-upper-limit]]

single-float [single-lower-limit [single-upper-limit]]

double-float [double-lower-limit [double-upper-limit]]

long-float [long-lower-limit [long-upper-limit]]

Compound Type Specifier Arguments:

short-lower-limit, short-upper-limit---interval designators for type short-float. The defaults for each of lower-limit and upper-limit is the symbol *.

single-lower-limit, single-upper-limit---interval designators for type single-float. The defaults for each of lower-limit and upper-limit is the symbol *.

double-lower-limit, double-upper-limit---interval designators for type double-float. The defaults for each of lower-limit and upper-limit is the symbol *.

long-lower-limit, long-upper-limit---interval designators for type long-float. The defaults for each of lower-limit and upper-limit is the symbol *.

Compound Type Specifier Description:

Each of these denotes the set of floats of the indicated type that are on the interval specified by the interval designators.


The following X3J13 cleanup issue, not part of the specification, applies to this section:


[Starting Points][Contents][Index][Symbols][Glossary][Issues]
Copyright 1996, The Harlequin Group Limited. All Rights Reserved.